MultiPlus Inverter/Charger 800VA - 1600VA
MultiPlus Inverter/Charger 800VA - 1600VA
PowerControl: Yes
PowerAssist: Yes
Three Phase: Yes
Parallel Operation: Yes
Transfer Switch: 16A
| 12 Volt Model | 12/800/35 | 12/1200/50 | 12/1600/70 |
|---|---|---|---|
| 24 Volt Model | 24/800/16 | 24/1200/25 | 24/1600/40 |
| 48 Volt Model | 48/800/9 | 48/1200/13 | 48/1600/20 |
| Continue output power | 800VA | 1200VA | 1600VA |
| Maximum efficiency | 92/93/94% | 93/94/95% | 93/94/95% |
| Charge current house battery (4) | 35/16/9A | 50/25/13A | 70/40/20A |
Proven reliability
The full bridge plus toroidal transformer topology has proven its reliability over many years. The inverter is short circuit proof and protected against overheating, whether due to overload or high ambient temperature.
PowerControl - Dealing with limited generator, shore side or grid power
With the Multi Control Panel a maximum generator or shore current can be set. The MultiPlus will then take account of other AC loads and use whatever is extra for charging, thus preventing the generator or shore supply from being overloaded.
PowerAssist - Boosting the capacity of shore or generator power
Where peak power is so often required only for a limited period, the MultiPlus will make sure that insufficient shore or generator power is immediately compensated for by power from the battery. When the load reduces, the spare power is used to recharge the battery.
High start-up power
Needed to start high inrush loads such as power converters for LED lamps, halogen lamps or electric tools.
Search Mode
When Search Mode is ‘on’, the power consumption of the inverter in no-load operation is decreased by approx. 70%. In this mode the Multi, when operating in inverter mode, is switched off in case of no load or very low load, and switches on every two seconds for a short period. If the output current exceeds a set level, the inverter will continue to operate. If not, the inverter will shut down again.
Programmable relay
By default, the programmable relay is set as an alarm relay, i.e. the relay will de-energise in the event of an alarm or a pre-alarm (inverter almost too hot, ripple on the input almost too high, battery voltage almost too low).
*Due to the complex nature of Victron Energy products and our desire for you to receive the correct product for your application, please call and speak to our knowledge team to order.